Single-component, bonding agent for the preparation of filler. STUCCO AQ mixed with fine sanding dust will have the same colour as the wood.
It can be used with waterborne finishes and impregnating oils.
- Very low environmental impact (EC1 Plus label)
- Excellent efficiency
- No colour change (preserves wood shade)
Bonding agent STUCCO AQ
Sand the floor with coarse and medium grained abrasive.
Mix STUCCO AQ with dust from the final sanding to form an homogeneous paste. Spread it quickly with a stainless, wide spatula (American spatula), pushing as much filler as possible into the cracks.
After drying, which normally requires 2-3 hours, sand or screen with fine abrasive, then vacuum and tack (with an antistatic cloth) thoroughly.
Should the filler shrink excessively in the largest cracks (over 2 mm), do the filling once again as described above.
Go on with the finishing or the impregnation.
- Before application, allow the wood manufacture and the product to reach a temperature between +15°C and +35°C.
- The support to be treated should have a moisture content inferior to 12%.
Dispose of excess product and empty containers properly!
If the original unopened container is stored in a cool and dry place, the product will keep for at least 12 months.